- CVE-2026-79982
The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and into whatever follows the statically allocated pool.
The device runs the local Bluetooth controller in raw HCI mode (CONFIG_BT_HCI_RAW), so the oversized packets originate over the air. With the HCI buffer sizes recommended for full-featured controllers, an unauthenticated attacker within Bluetooth range can supply the overflowing bytes: a connected peer that negotiates Data Length Extension can send ACL fragments up to CONFIG_BT_CTLR_DATA_LENGTH_MAX bytes, and an attacker that merely broadcasts extended advertising data reaches the same path through LE Extended Advertising Report events, which the controller fragments only to CONFIG_BT_BUF_EVT_RX_SIZE. In the stock configuration the overflow is already reached without any radio traffic: the mandatory Read Supported Commands command-complete event is 70 bytes and overruns the 64-byte slot by six bytes on every host initialization.
Because net_buf_add_mem() validates tailroom only through an assertion unless CONFIG_NET_BUF_HARDENING is enabled, builds with CONFIG_ASSERT=n — the usual production setting — silently corrupt memory adjacent to the USB buffer pool with attacker-chosen contents, which on a target without memory protection between subsystems can lead to arbitrary code execution. Builds with assertions enabled fail the assertion instead and panic, giving a remotely triggerable denial of service. The fix introduces a separate bt_hci_tx_pool sized to MAX(BT_BUF_ACL_RX_SIZE, BT_BUF_EVT_RX_SIZE) for the controller-to-host direction while leaving the host-to-device pool at the endpoint packet size, which is already bounds-checked during reassembly.
2026-10-23 · score 8.8
- CVE-2026-79979
The arm64 MMU backend invalidates a single virtual address from the TLB with invalidate_tlb_page() in arch/arm64/core/mmu.c, which issued TLBI VAE1{IS} with an operand of virt >> 12. That operand encodes the ASID in bits [63:48], so the invalidation only ever matched ASID 0 (the kernel page tables) and global entries. Memory domains, however, are allocated ASIDs starting at 1 in arch_mem_domain_init(), and every domain-private leaf created by private_map() is mapped with MT_NG, i.e. non-global. A domain's cached translation therefore survived the invalidation.
All callers of invalidate_tlb_page() are demand-paging paths. When the eviction algorithm reclaims a frame, page_frame_prepare_locked() in kernel/mmu.c calls arch_mem_page_out(), which marks the kernel leaf invalid, propagates the invalid descriptor into every domain via sync_domains(), and then flushes only ASID 0. do_page_fault() immediately reuses the very same page frame for the incoming mapping through arch_mem_page_in(). A user thread that had already touched the evicted page — a k_mem_partition added with arch_mem_domain_partition_add(), or its own stack mapped by map_thread_stack() — retains a valid EL0 read/write translation to that physical frame under its own ASID.
Unprivileged code running in a user thread can drive memory pressure to force eviction and then keep accessing the stale address, obtaining read and write access to whatever the kernel subsequently placed in that frame: supervisor data, another memory domain's partition, or another thread's stack. This defeats the isolation that CONFIG_USERSPACE is meant to enforce, allowing information disclosure and memory corruption up to full compromise of the system.
The fix switches the implementation to TLBI VAAE1{IS}, which matches every ASID and both global and non-global entries, so no domain-tagged translation survives a page out, dirty-bit update or access-flag clear. Exploitation requires an arm64 build with both CONFIG_USERSPACE and CONFIG_DEMAND_PAGING enabled, an active backing store, and at least one demand-paged page that is also privately mapped into a user memory domain. The same commit additionally stops globalize_table() from stripping EL0 permission and non-global attributes off domain-private leaves during paging synchronization, which previously caused user threads to lose access to their own partitions and stacks.
2026-10-23 · score 7.8
- CVE-2026-79977
The WireGuard VPN service in subsys/net/lib/wireguard/wg.c updated the peer endpoint from a message it could not authenticate. In handle_transport_data(), when the 32-bit receiver index of an incoming transport-data message matched no session, the code both scheduled a new handshake and copied the datagram's source address into peer->endpoint with memcpy(&peer->endpoint, peer_addr, sizeof(peer->endpoint)). Because the receiver index is unknown, there is no key with which such a message could be verified, so the address written into peer->endpoint is entirely attacker-supplied. Every other endpoint update in the implementation happens only after authentication — after the Noise handshake in handle_handshake_init(), or after AEAD decryption plus the anti-replay check in wg_process_data_message().
The WireGuard listener is registered with net_udp_register() using no remote address or port filter and defaults to UDP port 51820 (CONFIG_WIREGUARD_PORT), and wg_ctrl_recv() resolves the peer by interface rather than by any cryptographic identity. Any host able to send a UDP datagram to that port can therefore reach the defect off-path, with no need to observe legitimate traffic: a 16-byte datagram carrying the transport-data type, zeroed reserved bytes and an arbitrary receiver index is sufficient. The vulnerable branch runs whenever the peer has neither a valid handshake nor a current keypair — the state at boot and after a session expires.
A single spoofed datagram redirects peer->endpoint to an address of the attacker's choosing, and all subsequent handshake initiations, keepalives and encrypted data packets are sent there. The legitimate peer never receives the initiations and so never re-authenticates, and nothing resets the endpoint afterwards, leaving the tunnel persistently unusable on devices whose peer does not initiate handshakes itself. The attacker can also relay the redirected initiations to the real peer to place itself in the path of the tunnel, observing ciphertext and traffic metadata and selectively dropping packets. WireGuard's end-to-end cryptography still prevents decryption or forgery of tunnel content, so the impact is loss of availability plus limited confidentiality, not key compromise.
The fix removes the endpoint learning from this path entirely: the stale-session recovery is kept, but the handshake is sent only to an endpoint learnt from an authenticated message, falling back to the configured cfg_endpoint, and the message is dropped when neither is known. CONFIG_WIREGUARD is marked experimental and is not enabled by default.
2026-10-23 · score 8.2
- CVE-2026-19741
Zephyr's OpenThread integration defined CONFIG_OPENTHREAD_JOINER_PSKD with default "J01NME" in modules/openthread/Kconfig.thread (previously subsys/net/l2/openthread/Kconfig, then subsys/net/l2/openthread/Kconfig.thread). J01NME is the example Joining Device Credential used throughout the public OpenThread and Thread commissioning documentation, including Zephyr's own samples/net/sockets/echo_client/README.rst, so it is not a secret. A firmware image built with CONFIG_OPENTHREAD_JOINER_AUTOSTART=y that never overrode the PSKd therefore shipped with a publicly known joining credential compiled in, with no build-time or run-time warning.
The PSKd is the only value that authenticates Thread commissioning: joiner and commissioner run a DTLS-PSK handshake keyed on it, after which the commissioner supplies the full operational dataset. In ot_configure_instance() (modules/openthread/openthread.c), a device with no stored dataset calls otJoinerStart() with the configured PSKd, and ot_joiner_start_handler() calls otThreadSetEnabled() on success. An unauthenticated attacker within 802.15.4 radio range of an uncommissioned device (factory-fresh, after a factory reset, or after a settings erase) can run any stock Thread commissioner registered with J01NME, complete the handshake, and hand the device an attacker-controlled operational dataset.
The device then joins and enables Thread on the attacker's mesh. The attacker becomes its router, seeing, dropping, injecting and spoofing all of the device's IPv6 traffic and impersonating the peers the application expects, while the device is cut off from the network it was meant to join and stays mis-provisioned until it is reset. Only application-layer security with independently provisioned credentials survives. Exposure is limited to builds that enable joiner autostart and leave the PSKd unset; the option is not enabled by default and no in-tree sample uses the vulnerable combination.
The fix removes the default from CONFIG_OPENTHREAD_JOINER_PSKD and adds a BUILD_ASSERT() in modules/openthread/openthread.c, active only under CONFIG_OPENTHREAD_JOINER_AUTOSTART, that fails the build unless a 6-to-32-character PSKd is configured. Products should provision a per-device PSKd from factory data and call otJoinerStart() from the application rather than relying on a credential compiled identically into every unit.
2026-10-23 · score 7.5
- CVE-2026-115570
Electron is a framework for writing cross-platform desktop applications using JavaScript, HTML and CSS. Prior to 42.11.16, 43.8.1, 44.9.1, and 45.0.0-beta.6, Electron does not block compromised eMudhra intermediate certificates in Chromium networking, Node.js tls, Node.js https, or Node.js fetch. An attacker who holds a certificate issued through one of these intermediates and can intercept network traffic can impersonate a TLS server to an affected application. This issue is fixed in versions 42.11.16, 43.8.1, 44.9.1, and 45.0.0-beta.6.
2026-10-23 · score 7.4
